Ford Transit Service Indicator Reset Guide

This guide outlines how to reset the oil and service reminder on the most common Ford Transit generations, using procedures consistent with manufacturer recommendations. When a service notification or oil change reminder appears on the dashboard, it indicates that the vehicle has reached its scheduled maintenance interval. After performing an oil change or routine service, resetting the system is necessary so the next maintenance cycle can be calculated correctly.

Important: These instructions apply only to maintenance reminders. They do not cover the red oil pressure warning light or alerts caused by mechanical faults. Resetting the indicator will only clear the message and will not fix any underlying issue.

Ford Transit MK9 (2019+) Service and Oil Reset

Most Ford Transit MK9 models available in Europe allow resetting through the instrument cluster menu. Two common menu structures may be present depending on the software version.

Engine oil Ford Castrol Magnatec Professional E 5W20 1L new

Engine oil 15W40 Mobil Super 1000 1L new

Motor oil Omnicraft 5w30 1l Ford Transit new

engine oil D 0W30 1L Ford Castrol Magnatec Professional new

Ford Transit MK8 (2014-2019) Oil Reset Procedure

For most Transit MK8 vehicles, the reset is performed using the brake and accelerator pedals.

1. Switch the ignition ON without starting the engine.
2. Press the brake pedal fully.
3. Press the accelerator pedal fully.
4. Keep both pedals pressed simultaneously for around 20–25 seconds.
5. Wait until Oil Reset Complete appears on the display.
6. Release both pedals.
7. Turn the ignition OFF and restart the engine.

Some later MK8 versions may also allow resetting via the onboard menu.

Ford Transit MK6 / MK7 (2000-2013) Service Indicator Reset

Older Ford Transit MK6 and MK7 models typically use a similar pedal-based reset method. Depending on the version, messages such as Service Oil Soon or Service Oil Now may appear.

1. Turn the transit ignition to position II.
2. Do not start the engine.
3. Fully depress the brake pedal.
4. Fully depress the accelerator pedal.
5. Hold both pedals for at least 15 seconds.
6. Wait for the service message to flash or disappear.
7. Switch the ignition OFF.
8. Restart the vehicle to confirm the reset.

Reasons Why the Service Light Does Not Reset

If the reminder remains active after completing the steps, possible causes include:

• - Incorrect ignition setting during the procedure
• - Pedals not fully pressed
• - Insufficient time holding the reset sequence
• - Presence of an active fault code
• - Incorrect reset method for the specific model year

If the issue persists, diagnostic equipment may be required to complete the reset.

Engine Oil 0W30 5L Ford Castrol Magnatec ProfessionalCheck product →

Additional Recommendations

Always perform the reset only after completing the required maintenance work. Resetting the indicator without servicing the vehicle may result in incorrect service intervals. If you are unsure about your Ford Transit version, refer to the model identification section on our website.