The chassis and steering system of the 2016 Volkswagen Crafter II has been designed to handle heavy loads while ensuring comfort and precise control. With robust components such as leaf springs, shock absorbers and an advanced power steering system, the vehicle is ideal for commercial applications.
The chassis and steering system of the 2016 Volkswagen Crafter II has been designed to handle heavy loads while ensuring comfort and precise control. With robust components such as leaf springs, shock absorbers and an advanced power steering system, the vehicle is ideal for commercial applications.
Leaf springs for the 2016 Volkswagen Crafter
The Crafter II utilises multi-leaf springs on the rear axle to enable high load capacities. Common signs of problems with leaf springs are: 1. Uneven vehicle height: May indicate a broken or weakened leaf spring. 2. Excessive vibration: Often caused by worn or damaged components. 3. Noises from the suspension: Squeaking or rattling indicate misalignment or wear. When replacing, ensure compatibility with the respective Crafter model. Brackets and bushes should also be checked during the repair.
Servo pump in the Volkswagen Crafter II
The power steering system of the Crafter II uses a hydraulic pump for smooth control. Symptoms of a defective pump are: 1. difficult steering: stiffness or reduced responsiveness. 2. howling noises: indicate a low hydraulic fluid level or wear on the pump. 3. fluid leaks: can occur near the pump or on the connection hoses. Check the hydraulic fluid level regularly and change it according to the manufacturer's instructions. After replacing the pump, the system must be bled to avoid steering problems.
Upgrading the suspension in the VW Crafter 2016 to 5-tonne capacity
Upgrading the suspension in the Crafter II to increase the load capacity is a common modification. This process typically involves: 1. installing heavy-duty leaf springs for a 5-tonne capacity. 2. replacing the standard shock absorbers with reinforced versions. 3. adapting the rear axle to the new suspension system. A certified workshop should be consulted to ensure compliance and a correct installation.
How to remove the steering wheel in the Crafter II
Removing the steering wheel requires careful handling to avoid triggering the airbag. Steps to follow: 1. Disconnect the battery and wait 10-15 minutes. 2. Remove the airbag module by loosening the fastening screws behind the steering wheel. 3. Disconnect the airbag and steering wheel control cables. 4. Loosen and remove the central fastening screw. 5. Carefully pull the steering wheel off the hub. When reinstalling, the steering wheel must be aligned with the steering column and fastened with the central screw. After connecting the airbag system, its functionality should be checked. Less text